This is very rugged and reasonably power amplifier circuit that can be used for any audio applications. This is a good design for room audio. This circuit is based on transistor for the operation. This is the figure of the circuit.
The capacitor C1 controls low frequencies and capacitor C2 controls high frequencies. The circuit is basically a class B amplifier. The transistors 2N 3055 serves the function of driving the speaker. The other transistor functions as pre amplifiers for the driver stage. This is the basic scheme of the circuit. The maximum power level of amplifier can be set by adjusting the 500 Ohm POT connected with the BC107 transistor. The circuit can be powered using a 50 V DC power supply with 5A current rating. Power supply up to 60 V can be given to the circuit. Any way the power supply must be well regulated and filters to avoid noise. Volume control can be attained by connecting a 10 K POT in series to the input of the amplifier, but in the figure is not shown. Adjust the 500 ohm POT to obtain optimum performance. All capacitors must be rated higher than the supply voltage.
The capacitor C1 controls low frequencies and capacitor C2 controls high frequencies. The circuit is basically a class B amplifier. The transistors 2N 3055 serves the function of driving the speaker. The other transistor functions as pre amplifiers for the driver stage. This is the basic scheme of the circuit. The maximum power level of amplifier can be set by adjusting the 500 Ohm POT connected with the BC107 transistor. The circuit can be powered using a 50 V DC power supply with 5A current rating. Power supply up to 60 V can be given to the circuit. Any way the power supply must be well regulated and filters to avoid noise. Volume control can be attained by connecting a 10 K POT in series to the input of the amplifier, but in the figure is not shown. Adjust the 500 ohm POT to obtain optimum performance. All capacitors must be rated higher than the supply voltage.
0 comments:
Post a Comment