This is an audio line driver circuit using a TSH22. The advantages of this circuit are low distortion, exhibits a wide bandwidth and an output current sufficient to drive medium impedance loads at a high level modulation. This is the figure of the circuit;
This circuit uses two TSH22 that is used in non inverting mode. The gain of this circuit can be set by resistors. This circuit only uses a single power supply with voltage between 8V and 30V. A phantom ground at VCC/2 is made by two resistors (R4 and R6).
Following equations show the overall gain for frequency in the bandwidth :
Gain channel 1 = (R1 + R2)/R1
Gain channel 2 = (R8 + R9)/R8
[Circuit Schematic Source: STMicroelectronics Application Note]
This circuit uses two TSH22 that is used in non inverting mode. The gain of this circuit can be set by resistors. This circuit only uses a single power supply with voltage between 8V and 30V. A phantom ground at VCC/2 is made by two resistors (R4 and R6).
Following equations show the overall gain for frequency in the bandwidth :
Gain channel 1 = (R1 + R2)/R1
Gain channel 2 = (R8 + R9)/R8
[Circuit Schematic Source: STMicroelectronics Application Note]
0 comments:
Post a Comment